CG500 AND RNI-1500 INSTUCTIONS

INSTALL INSTUCTIONS
Written By Turtle Plates

  • REMOVE MOUNTING PLATE FROM BOX EITHER SHIPPING BOX OR ENCLOSURE

  • ⚠️PLEASE REMOVE PAPER MASKING ON MOUNTING PLATE FROM BOTH SIDES

  • MOUNT THE POWER SUPPLY TO PLATE VIA THE SUPPLIED SCREWS IN BAG LABLED POWER SUPPLY SCREWS

  • ⚠️REMOVE ONE SET OF STANDOFFS FROM THE BOARD IF YOUR USING A QUAD REMOVE THE UNO STANDOFFS IF USING A UNO REMOVE THE QUAD STANDOFFS . IF YOU NEED TO INSTALL A 2ND UNO IN THE SUPPLIED SPOTS YOU WILL NEED TO SUPPLY YOUR OWN M2 STANDOFFS

  • UNSCREW THE TOP SCREW OF THE STANDOFFS

  • PLACE CONTROLLER ON THE STANDOFFS

  • SCREW DOWN CONTROLLER

  • WIRE UP YOUR POWER SUPPLY TO YOUR CONTROLLER (UNO OR QUAD)

  • PLACE PLATE BACK IN BOX

  • SCREW PLATE INTO PLACE

  • RUN YOUR POWER CABLE IN ON LEFT BOTTOM SIDE OF ENCLOSURE THROUGH THE FOAM

  • RUN YOUR PIGTAILS OUT THE OTHER REMAINING HOLES IN THE FOAM AT THE BOTTOM OF ENCLOSURE

Turtle Plates
Previous

Wled & Xlights